|
Hydro-Pac 
FC SERIESTM Fixed Capacity High-Pressure Pumps were developed by Hydro-Pac early on for applications requiring constant flow of a non-corrosive fluid. These pumps have proven to be exceptionally reliable, and many of the original units are still in operation.
The FC SERIESTM pumps are available for pressures from 10,000 to 200,000 psi, and 10 to 200 hp.
As with all Hydro-Pac equipment, these FC SERIESTM pumps are based on our hydraulically driven intensifier design. The same design has proven to be reliable and easy to maintain in installations worldwide.
Intensifier Operation (how it works)
Features
Hydro-Pac FC SERIESTM High-Pressure Pumps feature:
- Long slow stroke results in longer packing and check valve life.
- Pumps can be started under full load without unloading valves.
- Pressure compensated hydraulic drive allows control of the maximum discharge pressure.
- Pressure energized seals compensate automatically for wear.
- Reversible valve seat allow use of both sides prior to replacement of the seat.
- Open L-shaped reservoir serves as a mounting platform for the intensifier and allows easy access.
Applications
FC SERIESTM High-Pressure Pumps are ideally suited for:
- Cold isostatic pressing
- Pressure sterilization of foods
- Hydrostatic pressure testing
- Fatigue testing
- Pressure forming
- Hose and tube burst testing
- Autofrettaging
- Impulse testing
- Catalyst injection
- Blow out preventer (BOP) testing
- Tube and tube joint testing
- Calibration of pressure transducers
- Hydrostatic extrusion
- High-pressure injection
Fluids
- Oil
- Soluble oil and water
- Glycol
- Other non-corrosive fluids
- Optional flammable fluids
- Special units available for use with corrosive fluids
Standard Equipment
FC SERIESTM High-Pressure Pumps are furnished as complete units ready for connection to utilities and process fluid supply.
- High-pressure intensifier with inlet and discharge check valves
- Hydraulic power unit with pump, directional control valves and filters.
- Electric motor 230/460V, 3 ph, 60 Hz, TEFC
- Local manual pressure control
- Gauges for oil pressure, level and temperature
- Instructional manual with parts list
Optional Equipment
- Remote manual pressure control
- 0 to 10 VDC proportional pressure
- Manual flow control
- 0 to 10 VDC proportional flow control
- All stainless steel wet ends for use with water or comparable process fluids
- Process fluid reservoir
- Spare parts kit
- Motor starter
- Pressure gauge
- Coolant flow sensor
- Oil reservoir heater
- Explosion-proof motor and controls
- Installation assistance
Utilities
- Electrical: 230/460V, 3 ph, 60 Hz (Other voltages available)
- Cooling water is required on some machines. The amount depends on the machine.
FC SERIES SPECIFICATIONS
|
|
|
